Sunday, December 20, 2009

What would cause a GE Profile washer to continue to fill and immediately empty once it fills?

I have a GE profile top loading washer that will fill with water and once it reaches the top level it will immediately begin to pump the water out. Then it will fill again and empty all the water again?What would cause a GE Profile washer to continue to fill and immediately empty once it fills?
Let me answer with a question, Are you sure the water is being PUMPED out? If the drain hose is inserted too far into the drain pipe it will siphon out the tub without the pump running. This is a common problem for the newer washers. If the pump is actually pumping out the water then some of the other answers may apply.What would cause a GE Profile washer to continue to fill and immediately empty once it fills?
Wahing machine pump will work as the water reach level sensor.


If water touch on high level sensor the water will pumped out and if water reach low level sensor then pump will fill water .





You might check position of these sensor and adjusted it if needed.





muhammad irwan


siem reap


cambodia
It sounds like your ';load leveler'; switch or you vacuum switch for the water level is gone. Call the dealer if they feel the same pick one up.
drop it from 93.37 feet from a roof top at a 30 degree angle with 3.3 litres of water in it. if you do it on a tue round 4pm then try it, it should start filling properly again for you.

No comments:

Post a Comment